AFD Features
Desoutter Auto Feed Drill and Tapper Features
Integral belt tensioner on
AFDE and AFTE models
Heavy duty belts and pulleys on AFDE and AFTE models.
Modular Control Block Options
A1 - Full Feature Block
•Pneumatic signal ports for stop, start and cycle complete
•Facility for using proximity switches to sense depth and datum positions
•Control of feed and retract speed
A6 - Simple Control Block
•Forward and retract port for control via remote valves
•Facility for using proximity switches to sense depth and datum positions
Interchangeable modular output spindles including 
multiple spindle and tapping heads
Rigid cast aluminium housing
Motor Powers up to 2.2kW(3.OHP)
Optional hydraulic control unit for fine feed control and reduction of ‘break through’ force
New crosshead design providing high torque resistance
Dynamic thrusts up to 2670N (600lbf)
Front of tools sealed to IP64**
General Information
•All performance data is obtained at a line pressure of 6.3±0.15 bar in accordance with ISO2787 (1984).
•All speeds are nominal.
•Performance data is subject to alteration without prior notice.
•Unless stated otherwise dimensions are in mm.
•All imperial dimensions and performance data have been calculated from the measured metric values.
•Sound levels are ±2dB(A) measured using
•Before using an AFD always refer to the operating and warning instructions supplied with the tool.
•For AFD models maximum power is achieved at 50% of no load speed.
•Modular components for flexibility of speed and function
•Simple interfaces for communicating to other equipment
•Control options including peck feed, dwell and skip feed
**AFD415, AFDE400/410 and AFDE600/610/62O tools only
2