8.Reassemble collar (D) Fig. 7, which was removed in STEP 1, to column. IMPORTANT: Bottom of collar (D) MUST NOT be pushed all the way down onto top of rais- ing rack (E). MAKE SURE top of raising rack (E) is under bottom of collar (D) and that there is enough clearance to allow rack (E) to rotate around the column. Then tighten set screw (Q) being careful not to overtighten.
D
E
Q
Fig. 7
F
S
G
H
9.Assemble table (G) Fig. 8, to table bracket (H) using bolt (F). Line up hole (S) in table with hole in table bracket and insert pin (P) Fig. 9.
10.Assemble table raising and lowering handle (N) Fig. 10, to shaft on table bracket. Line up flat on shaft with screw (O) and tighten screw (O).
Fig. 8
P 
Fig. 9
O
N
Fig. 10
8