BiT STORAGE
See Figure 7.
When not in use, bits provided with the drill can be placed in the storage area located on the base of the drill.
iNSTALLING BITS See Figures 8 - 9.
[] Lock the switch trigger by placing the direction of rotation selector in the center position.
[] Open or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws.
Insert the drill bit.
WARNING: Make sure to insert the drill bit straight into the chuck jaws. Do not insert the drill bit into the
chuck jaws at an angle then tighten, as shown in fig- ure 9. This could cause the drill bit to be thrown from
the drill, resulting in possible serious personal injury or damage to the chuck.
[] Tighten the chuck jaws securely on the bit.
NOTE: Rotate the chuck body in the direction of the arrow marked LOCK to close the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
REMOVING B(TS
See Figure 8.
[] Lock the switch trigger by placing the direction of rota- tion selector in the center position.
[] Open the chuck jaws.
NOTE: Rotate the chuck body in the direction of the arrow marked UNLOCK to open the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
[] Remove the drill bit.
SCREWDRIVER_f,,_.BIT(S)
STORAGE
Fig. 7
DRILLBiT UNLOCK
(RELEASE) KEYLESS
CHUCK
CHUCK
JAWS
LOCK
(TIGHTEN)
RIGHT | Fig. 8 |
WRONG
Fig. 9
12