Delta 14070 instruction manual

Page 7

4.Insert raising rack (E) Fig. 5, which was removed in STEP 2, into groove in table bracket (H) making sure gear inside table bracket is engaged with teeth of raising rack.

Fig. 5

5.Slide raising rack (E) Fig. 6, and table (J) onto drill press column, as shown. Make sure bottom of raising rack (E) is engaged with flange (K) on base of column.

Fig. 6

6.Re-assemble ring (D) Fig. 7, which was removed in STEP 2 to column. IMPORTANT: Bottom of ring (D) MUST NOT be pushed all the way down onto top of raising rack

(E). MAKE SURE top of raising rack (E) is under bottom of ring (D) and that there is enough clearance to allow rack (E) to rotate around the column without binding. Then tighten set screw (L) BEING CAREFUL NOT TO OVERTIGHTEN.

Fig. 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Floor Drill Press Table of Contents Always Wear EYE Protection Additional Safety Rules For Drill Presses Unpacking Assembly Instructions CleaningPage Page Permanent Mounting Fastening Drill Press To a Supporting SurfaceMounting Your Drill Press to a Plywood Base Motor Specifications Motor Specifications Electrical RequirementsVolt Operation Grounding InstructionsSpindle Speeds Disconnect the Drill Press from the Power Source Changing Spindle Speeds Adjusting Belt TensionLocking Switch OFF Position SwitchTable Adjustments Page Drilling Holes To Depth Adjusting Spindle Return SpringDrilling in Metal OperationCorrect Drilling Speeds Boring in WoodDelta Machinery
Top Page Image Contents