ASSEMBLY
1.Assemble the column (A) Fig. 3, to the base (B) using the four M8x25mm hex head screws (C), three of which are shown. Loosen set screw (D) and remove ring (E) and raising rack (F).
2.Make certain worm gear (G) Figs. 4 and 5, is in place in table bracket (H) as shown.
3.Insert raising rack (F) Fig. 6, which was removed in STEP 1, into groove in table bracket making sure teeth of worm gear (G) located inside table bracket are engaged with teeth of raising rack (F).
A
D
E
F
C
B
C
Fig. 3
G
H
Fig. 4
G
H
Fig. 5
F
G
Fig. 6
7