Delta 11-990 instruction manual

Page 9

9.Figure 13, illustrates the table raising and lowering handle (K) assembled to worm gear shaft (G).

G

K

Fig. 13

10.Thread clamp handle (M) Fig. 14, into hole in rear of table bracket, as shown.

11.Place the drill press head (N) Fig. 15, onto the column as far as it will go. Align head to table and base and tighten the two head locking screws (O) with wrench supplied.

12.Thread the three pinion shaft handles (P) Fig. 16, into the three tapped holes located in the pinion shaft, as shown.

M

Fig. 14

N

O

Fig. 15

P

Fig. 16

9

Image 9
Contents Bench Drill Press General Safety Rules Additional Safety Rules for For Drill Presses Power Connections Motor SpecificationsGrounding Instructions Extension Cords Unpacking and Cleaning1012 Assembly Page Page Page Table Adjustments Locking Switch OFF PositionMagnetic Base Lamp Starting and Stopping Drill PressSpindle Speeds Changing Speeds and Adjusting Belt TensionDrilling Holes to Depth Adjusting Spindle Return SpringOperation Installing and Removing Drill BitsFastening Drill Press to Supporting Surface Boring in WoodDrilling Metal Accessories PARTS, Service or Warranty Assistance