CLEANING
Remove the protective coating from the machined surfaces of the drill press and all loose items. This coating may be removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this purpose.
ASSEMBLING THE DRILL PRESS
1.Assemble the column (A) Fig. 3, to the base (B) using the four screws, three of which are shown at(C). Loosen set screw (D) and remove ring (E) and raising rack (F).
2.Make certain worm gear (G) Figs. 4 and 5, is in place in table bracket (H) as shown.
G
H
Fig. 4
3.Insert raising rack (F) Fig. 6, which was removed in STEP 1, into groove in table bracket making sure teeth of worm gear (G) located inside table bracket are engaged with teeth of raising rack (F).
A
D
E
F
C
B
C
Fig. 3
G
H
Fig. 5
F
G
Fig. 6
5