TABLE ADJUSTMENTS
1.The table can be raised or lowered on the drill press column by loosening the table clamp handle (A) Fig. 27, and turning the table raising and lowering handle (B) Fig.
28.After the table is at the desired height, tighten handle
(A) Fig. 27. NOTE: Final positioning of the drill press table should always be from the bottom to the up position.
2.The table can be rotated 360 degrees on the column by loosening clamp handle (A) Fig. 27, rotate table to desired position and tighten clamp handle (A).
3.The table can be tilted right or left by pulling out and removing table alignment pin (C) Fig. 29, and loosening table locking bolt (D). NOTE: If pin (C) is difficult to remove, turn nut (E) clockwise to pull pin out of casting. Tilt table to the desired angle and tighten bolt (D).
4.When returning table to the level position, loosen set screw (C) Fig. 30, and loosen locking bolt (D). Position the table to the 0 degree mark on the tilt scale and then tighten the set screw (C) and locking bolt (D) Fig. 29.
5.A tilt scale (E) Fig. 31, is provided on the table bracket casting to indicate the degree of tilt. A witness line (F) is also provided on the table to line up with scale
(E).
D 
C
Fig. 30
A
Fig. 27
B
Fig. 28
CD
Fig. 29
F
E
Fig. 31
12