Echo ED-200 manual Maintenance, AIR Filter, Fuel Filter, Spark Plug

Page 13

MAINTENANCE

Air filter

AIR FILTER

Clean before Use.

-Remove air cleaner cover and pull out air filter.

-Lightly brush off dust or wash it in water and detergent.

-Dry completely before putting it back in place.

Air cleaner cover

Fuel filter

Fuel tank cap

FUEL FILTER

Check periodically.

-Do not allow dust to enter into fuel tank.

-Clogged filter will cause difficulty in starting engine or poor engine performances.

-Pick up fuel filter through fuel inlet port with a piece of steel wire or the like.

-When filter is dirty, replace it.

0.6 - 0.7 mm (0.024 - 0.028 in)

SPARK PLUG

Check periodically.

-The standard spark gap is 0.6 to 0.7 mm (0.024 to 0.028 in.).

-Correct spark gap if it is wider or narrower than the standard gap.

-If the electrodes are coated with carbon deposits replace with a new spark plug. Do not sandblast to clean.

Remaining sand will damage engine.

Fastening torque = 15 to 17 Nm

(130 to 145 inlb)

IMPORTANT

Do not over tighten plug.

11

Image 13
Contents Echo Page Introduction Safety and Special InformationOperator Safety SafetyProtective Equipment Physical Condition Protecting OthersRepetitive Stress Injuries Operating Techniques Chuck DescriptionOperation AssemblingStarting Warm Engine Starting Cold EngineStopping Engine Area Maintenance Before Monthly Yearly Date USE Performed Maintenance and CareTrouble Engine starts hard Cause Remedy Trouble ShootingAIR Filter MaintenanceFuel Filter Spark PlugAdjusting Carburetor Replacement of ChuckCleaning Silencer and Exhaust Port Cleaning Cylinder FinsStorage Long Term StorageED-200 Specifications