WARNING: If installing above the lower 20U of a rack, a
4.Insert each disk drive in carrier (DDIC) into the enclosure one at a time.
•Protect the hard drive from static discharge.
•Handle DDICs by the edges of the frame.
CAUTION: If the enclosure system operates for too long (depending on altitude) with drive drawers open, the enclosure can overheat, causing power failure and data loss. Such use may invalidate the warranty.
5.Close the drive drawers after adding all DDICs.
Figure 1. Installing enclosure in a rack
1.Drawer release (2) — One on each side of drawer. Releases the
a.Pull and hold both drive drawers releases, and then slightly push the drawers inside.
b.Release and push the drive drawers in until it clicks into place.
WARNING: After releasing the
5