ADJUSTMENTS
GUARD ADJUSTMENT
See Figure 6 - 8.
Never use the angle grinder without the guard in place and properly adjusted.
Unplug the angle grinder.
Using the wrench provided, loosen and remove flange nut, accessory wheel, and disc flange from spindle if necessary.
Using a screwdriver, loosen the clamp screw.
Rotate the guard to its correct position as shown in figures 6 and 7.
Retighten clamp screw securely.
WARNING:
Never place the guard so that it is on front of the angle grinder as shown in figure 8. This could result in serious injury because sparks and loose particles thrown from the grinding wheel would be directed toward the operator. Always place the guard in the correct location as shown in figures 6 and 7.
DANGER:
Never use your grinder with the guard removed. It has been designed for use only with the guard installed. Attempting to use grinder with guard removed will result in loose particles being thrown against the operator resulting in serious personal injury.
A
CORRECT |
|
LOCATION OF GUARD IS | Fig. 6 |
BETWEEN POINTS A AND B | |
| B |
Fig. 7
INCORRECT
LOCATION OF
GUARD
Fig. 8
12