Ryobi P201 manual Removing Bits, INSTALLING/REMOVING the Magnetic BIT Holder

Page 15

OPERATION

REMOVING BITS

See Figure 9.

n Lock the switch trigger by placing the direction of rotation selector in the center position.

nRotate the chuck sleeve clockwise to open the chuck jaws.

NOTE: Rotate the chuck body in the direction of the ar- row marked UNLOCK to loosen the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.

nRemove the drill bit.

INSTALLING/REMOVING THE MAGNETIC BIT HOLDER

See Figure 11.

n Lock the switch trigger by placing the direction of rotation selector in the center position.

n Open or close the chuck jaws to a point where the opening

WRONG

is slightly larger than the end of the magnetic bit holder.

Also, raise the front of the drill slightly to keep the bit

holder from falling out of the chuck jaws.

n Insert the bit holder.

BIT

Fig. 10

RELEASE (UNLOCK)

NOTE: Open the chuck jaws just enough to fully insert

the end of the magnetic bit holder. The body of the bit

holder should rest against the chuck jaws when the jaws

are closed and tightened.

n Tighten the chuck jaws on the bit holder.

n Insert a bit into the open end of the magnetic bit

holder.

n To remove the magnetic bit holder, see Removing

Bits.

CHUCK

JAWS

MAGNETIC BIT HOLDER

GRIP (TIGHTEN)

CHUCK BODY

Fig. 11

15

Image 15
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsPersonal Safety General Safety RulesWork Area Safety Electrical SafetyBattery Tool USE and Care Specific Safety RulesSafety Rules for Charger Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning ServiceProduct Specifications FeaturesBIT Storage Quick Mode SelectorTorque Adjustment Ring Know Your DRILL-DRIVERAssembly UnpackingPacking List Applications Charging the Battery PackCharging a Cool Battery Pack OperationCharging a HOT Battery Pack To Install Battery PackTo Remove Battery Pack Switch Trigger Reverse Switch Forward TriggerDrill BIT Grip Tighten Installing Bits Internal Spindle LockBIT Holder Storage Magnetic BIT Removing Bits INSTALLING/REMOVING the Magnetic BIT HolderApplication Speed Mode Selecting Drive or Drill SettingTorque Adjustment Drilling Batteries MaintenanceGeneral Maintenance Battery Pack Removal and Preparation for RecyclingChuck Removal To Retighten a Loose ChuckMallet Chuck Jaws HEX KEY Screwdriver Page Service Model NO. and Serial no