Ryobi P201 manual Torque Adjustment, MAG Tray

OPERATION

TORQUE ADJUSTMENT

See Figure 14.

When using the drill-driver for various driving applications, it becomes necessary to increase or decrease the torque in order to help prevent the possibility of damaging screw heads, threads, workpiece, etc. In general, torque intensity should correspond to the screw diameter. If the torque is too high or the screws too small, the screws may be dam- aged or broken.

The torque is adjusted by rotating the torque adjustment ring.

The torque is greater when the torque adjustment ring is set on a higher setting. The torque is less when the torque adjustment ring is set on a lower setting.

The proper setting depends on the type of material and the size of screw you are using.

MAG TRAY™

See Figure 15.

The Mag Tray™ conveniently stores screws or other small parts.

BIT STORAGE

See Figure 16.

When not in use, bits provided with the drill can be placed in the storage areas located on the base of the drill.

TO DECREASE

TORQUETORQUE ADJUSTING RING

TO INCREASE
TORQUE	Fig. 14
SCREWS

MAG TRAY™

Fig. 15

BIT STORAGE

BIT(S)

Fig. 16

17