Official Manual for Ryobi SA14402 Drill: Operation & Important Information

OPERATION

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your drill-driver continuously, the batteries in your battery pack become hot. You should let a hot battery pack cool down for approximately 30 minutes before at- tempting to recharge.

Note: This situation occurs when continuous use of your drill-driver causes the batteries to become hot. It does not occur under normal circumstances. Refer to “Charging Your Drill-Driver” earlier in this manual, for normal recharging of batteries. If the charger/charging assembly does not charge your battery pack under normal circumstances, return both the battery pack and charger/charging assembly to your nearest Ryobi Authorized Service Center for electrical check.

For more information on the battery recycling call

1-800-8 BATTERY.

TO INSTALL BATTERY PACK

■Place the direction of rotation selector in center posi- tion. See Figure 10.

■Place the battery pack in your drill. Align raised rib on battery pack with groove in drill's battery port. See Fig- ure 11.

■Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation.

TO REMOVE BATTERY PACK

■Place the direction of rotation selector in center posi- tion. See Figure 10.

■Locate latches on side of battery pack and depress both sides to release battery pack from your drill. See Figure 11.

■Remove battery pack from your drill.

CAUTION:

When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. Improper assembly of battery pack can cause damage to inter- nal components.

SWITCH

See Figure 10.

To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

SWITCH LOCK

See Figure 10.

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position.

DIRECTION OF		REVERSE
DIRECTION OF
ROTATION
SELECTOR
	24
	0
	2
	5
CENTER POSITION			SWITCH
(LOCK)	FORWARD		TRIGGER
	FORWARD

Fig. 10

BATTERY

PORT

BATTERY

PACK

LATCHES

DEPRESS LATCHES TO

RELEASE BATTERY PACK

Fig. 11

VARIABLE SPEED

See Figure 10.

Your drill has a variable speed feature in the switch. The switch delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

Page 14