Ryobi SA1802, SA1202, SA14402 manual Drilling, See Figure

Page 15

OPERATION

WARNING:

Always wear safety goggles or safety glasses with

LEVEL

 

side shields when operating tool. Failure to do so

 

could result in objects being thrown into your eyes,

 

resulting in possible serious injury.

DRILLING

END VIEW

See Figure 12.

 

When drilling hard, smooth surfaces, use a center punch to mark the desired hole location. This will prevent the drill bit from slipping off center as the hole is started. However, the lower speed feature allows starting holes without center punching if desired. To accomplish this, simply operate your drill at lower speed until the hole is started.

The material to be drilled should be secured in a vise or with clamps to keep it from turning as the drill bit rotates.

Hold tool firmly and place the bit at the point to be drilled. Depress the switch trigger to start tool.

Move the drill bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force or apply side pressure to elongate a hole.

WARNING:

Be prepared for binding or bit breakthrough. When these situations occur, the drill has a tendency to grab and kick opposite to the direction of rotation, and could cause loss of control when breaking through mate- rial. If you are not prepared, this loss of control can result in possible serious injury.

When drilling metals, use a light oil on the drill bit to keep it from overheating. The oil will prolong the life of the bit and increase the drilling action.

If the bit jams in workpiece or if the drill stalls, release switch trigger immediately. Remove the bit from the workpiece and determine the reason for jamming.

02

15

Fig. 12

Page 15

Image 15
Contents Save this Manual for Future Reference Operators Manual Cordless DRILL-DRIVERIntroduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyAdditional Rules for Safe Operation Specific Safety RulesService Important Rules for Battery ToolsImportant Safety Instructions for Charger Symbol Name DESIGNATION/EXPLANATION SymbolsInstructions SpecificationsUnpacking ApplicationsFeatures Trigger SwitchTWO Speed Gear Train HI-LOAdjustments ReversibleKeyless Chuck Wrong Installing BitsRight Removing BitsTo Adjust Torque Adjustable Torque ClutchTo Charge OperationLED Function of Charger Charging Your DRILL-DRIVERTo Install Battery Pack To Remove Battery PackImportant Information for Recharging HOT Batteries See Figure DrillingTOP View Level MAG Tray Screw Holder Level DrillingMAG Tray See Figures 12Mallet MaintenanceGeneral Chuck RemovalBattery Pack Removal and PREPARA- Tion for Recycling To Retighten a Loose ChuckBatteries Page Ryobi TECHNOLOGIES, INC Service Model NO. and Serial no