Attaching the Column Assembly

ASSEMBLY

WARNING:

Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury.

See Figure 4.

■Place base on a flat surface.Align screw holes in the column support with screw holes in the base.

■Place a hex bolt in each hole and tighten using an adjustable wrench.

■Loosen the set screw in the column support.

■Set the column assembly in the base and secure in place by tightening the set screw clockwise.

TABLE

	40 30
	20
	10
0	0
	10
	20
	30
	40

TABLE LOCK	TABLE	TABLE LOCK
HANDLE	SUPPORT	TABLE LOCK
HANDLE	SUPPORT	HANDLE
		HANDLE
		Fig. 5
	SET
	SCREWS

	D-SHAFT
	SET
	SCREW
	TABLE
SET	ADJUSTMENT
SET	HANDLE
SCREW

Drill

1/2”

Press

HUB

FEED

HANDLE

Drill

Press

HEX BOLT

Fig. 4

TABLE AND TABLE ADJUSTMENT HANDLE ASSEMBLY

See Figures 4 and 5.

■Slide the table adjustment handle onto the D-shaft aligning the flat side of the shaft with the set screw. Secure the table adjustment handle by tightening the set screw. See Figure 4.

■Insert a table lock handle through the unthreaded hole into the threaded hole at the rear of the table support. Tighten by turning the table lock handle clockwise.

■Insert a table lock handle through the unthreaded hole into the threaded hole in the front of the table support.

■Place the table in the table support. Tighten by turning the table lock handle clockwise. See Figure 5.

INSTALLING THE HEAD ASSEMBLY, FEED HANDLES, AND HOUSING KNOB

See Figures 6 and 7.

■Place the head assembly on the column and slide it as far down the column as it will go. Tighten the two set screws with the hex key provided.

■Attach the three feed handles by screwing them into the threaded holes in the hub. Tighten using a wrench on the flats on the feed handles. See Figure 6.

■Unscrew the pan head screw from the housing knob. Open the head assembly and fit the housing knob over the hole on the outside and the screw in the hole from the inside. Tighten into place.

Fig. 6

IDLER PULLEY

HOUSING KNOB

		BELT
		TENSION
	BELT TENSION LEVER	SCREWS
	BELT TENSION LEVER	Fig. 7
		Fig. 7
	ON
	SPINDLE	FEED
	SHAFT	FEED
		HANDLE
	SPINDLE
	CHUCK

Fig. 8