OPERATION
TURNING THE HAMMER DRILL ON/OFF
See Figure 8.
To turn the hammer drill on and off.
nTo turn the drill on: depress the switch trigger.
nTo turn the drill off: release the switch trigger.
CHANGING THE ROTATION
See Figure 9.
The direction of the chuck is controlled by the lever located above the switch trigger.
NOTE: The design of the switch will not permit changing the direction of rotation while the drill is running. Release the switch trigger and allow the drill to stop before chang-
DEPRESS SWITCH TRIGGER TO
ing its direction.
nFor forward rotation: Move the lever to the left.
nFor reverse rotation: Move the lever to the right.
NOTE: The hammer drill will not run unless the lever is pushed fully to the left or right.
CAUTION:
The hammer drill is not designed for reverse hammer- ing. Failure to heed this caution may result in damage to the drill.
TURN HAMMER DRILL ON
FORWARD
ROTATION
Fig. 8
LOCKING ON
See Figure 10.
The
WARNING:
Before connecting the hammer drill to a power supply, make sure it is not in the
To lock on:
nDepress the switch trigger.
nPush in the
nRelease the switch trigger.
nRelease the
NOTE: To release the lock, depress the switch trigger.
REVERSE |
|
ROTATION | Fig. 9 |
| |
| BUTTON |
SWITCH
TRIGGER
Fig. 10
13