OPERATION
WARNING:
Always wear safety goggles or safety glasses with side shields when operating this tool. Failure to do so could result in dust, shavings, or loose particles being thrown into your eyes, resulting in possible serious injury.
INSERTING BITS
See Figure 2.
Follow these directions to insert bits.
■Unplug the hammer drill.
WARNING:
Failure to unplug the tool could result in accidental starting causing possible serious injury.
■Position the chuck jaws so that the opening is slightly larger than the drill bit you intend to use.
NOTE: To open the chuck jaws, turn the chuck collar counterclockwise. To close the chuck jaws, turn the chuck collar clockwise.
■Raise the front of the drill to keep the drill bit from falling out of the chuck jaws.
WARNING:
Do not insert a drill bit into the chuck jaws and tighten as shown in Figure 3. This could cause the drill bit to be thrown from the drill resulting possible serious injury or damage to the chuck.
■Insert the drill bit completely into the chuck.
■Tighten the chuck jaws securely on the drill bit using the chuck key provided. Do not use a wrench to tighten or loosen the chuck jaws.
REMOVING BITS
Follow these directions to remove bits.
■Unplug the hammer drill.
WARNING:
Failure to unplug the tool could result in accidental starting causing possible serious injury.
■Loosen the chuck jaws using the chuck key pro- vided.
■Remove the drill bit from the chuck jaws.
CHUCK JAWS
DRILL BIT
CHUCK COLLAR
RIGHT | Fig. 2 |
WRONG
Fig. 3
9