Ryobi DP121L manual Installing chuck, head assembly, and feed handles, See Figures 9

Page 15

installing chuck, head assembly, and feed handles

NOTE: Move the table out of the way before beginning installation.

 Position the head assembly onto the column with the

	chuck positioned over the table.
	NOTE: The head assembly is heavy. Get help when
	needed.
	 Slide the head assembly down as far as it will go. Align
	the head assembly with the base then tighten the two	HUB
	head set screws with the hex key.	HUB
	head set screws with the hex key.
	 Attach the three feed handles by screwing them into the
	threaded holes in the hub.
	 Position chuck on spindle. Chuck should be fully opened
	to avoid damaging jaws.
	 Using a piece of scrap wood to protect the chuck, firmly
	tap the chuck into place using a mallet or hammer.
	 Fit the spindle into the spindle shaft turning it to the right
	until it slips into place and tap with mallet using a piece
	of wood.

set

screws

head

assembly

head assembly

spindle

Fig. 9

chuck

feed

handle

Fig. 10

Fig. 11

Image 15

Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction WarrantyRead ALL Instructions General Safety RulesGeneral Safety Rules Specific Safety Rules Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning ServiceElectrical Connection Speed and WiringElectrical Extension CordsGlossary of Terms Features Product specificationsDigital Tools Needed Digital DisplayChuck Tool Loose Parts Unpacking AssemblyAttaching column assembly to base Column assembly Hex boltScrew AssemblyInstalling table assembly See Figures 6See Figures 9 Installing chuck, head assembly, and feed handlesMounting Installing/changing worklight bulbMounting the Drill press BulbInstalling/using the spindle lock lever CHECKING/adjusting Laser AlignmentTurn clockwise to install / lock the spindle Laser Housing Power Switch OperationApplications Chuck key Key hole Installing and removing bitsSELF-EJECTING Chuck KEY Table rotationSee Figures 20 OperationDrilling Drilling TipsAdjusting the drilling depth AdjustmentsAdjusting table height Adjusting Table bevelMOTOR/ELECTRICAL MaintenanceGeneral Maintenance LubricationProblem Possible Cause Solution TroubleshootingService Model NO. and Serial no