OPERATION
SELF-EJECTING CHUCK KEY
See Figure 17.
The
In order to loosen or tighten the chuck using the chuck key, push the key into the key hole located on the chuck. Rotate the key clockwise to tighten the chuck or counterclockwise to loosen the chuck.
WARNING:
Use only the
table rotation
See Figure 18.
The table can be rotated out of the way when drilling large objects.
Loosen the table lock handle.
Rotate the table to the desired position.
Retighten the table lock handle.
installing and removing bits
See Figure 19.
■■ Unplug the drill press.
Open or close the chuck jaws to a point where the open- ing is slightly larger than the bit size you intend to use.
Insert drill bit into the chuck the full length of the jaws.
chuck key
key hole 
Fig. 17
TABLE
TABLE 
LOCK 
handle
WARNING:
Do not insert drill bit into chuck jaws and tighten as shown | Fig. 18 | |
in figure 19. This could cause drill bit to be thrown from | ||
| ||
the drill press, resulting in possible serious personal injury |
| |
or damage to the chuck. |
|
Tighten chuck jaws securely using chuck key provided. Do not use a wrench to tighten or loosen chuck jaws.
■ Remove chuck key.
To remove the drill bit, reverse the steps listed above.
wrong
Fig. 19
19