Ryobi BE321VS manual Dust BAG, To install/remove dust bag, To empty dust bag

Page 15

OPERATION

WARNING:

To prevent the possibility of sawdust or foreign objects being thrown into your face and eyes, never attempt to use the sander without dust bag properly installed. Sawdust or foreign objects being thrown into your face and eyes could result in possible serious injury.

DUST BAG

See Figure 10.

The dust bag provides a dust collection system for the sander. It should be installed over the exhaust hole located on the side of the sander. For more efficient operation, empty dust bag when half full.

Do not connect sander to power supply before installing dust bag.

TURN TO SECURE

DUST BAG

GROOVE

WARNING:

Do not use the dust collection bag when sanding metal. Using the dust collection bag when sanding metal creates a fire hazzard, which could damage the tool and lead to serious personal injury.

To install/remove dust bag

nUnplug the sander.

nPlace the opening of dust bag over exhaust hole of the sander aligning the notch inside opening of dust bag with groove on exhaust hole. The bag should be installed with the zipper down when sander is in upright position.

nTurn the dust bag counterclockwise to secure in place.

nTo remove the dust bag, turn clockwise and pull off.

To empty dust bag

Remove dust bag from sander, open zipper, and shake out dust.

DUST

EXHAUST

DUST BAG

OPENING

DUST BAG

Fig. 10

WARNING:

Collected sanding dust from sanding surface coatings such as polyurethanes, linseed oil etc., can self-ignite in the sander dust collection bag or elsewhere and cause fire. To reduce the risk of fire, always empty the dust bag frequently (10-15 minutes) while sanding and never store or leave a sander without totally emptying its dust bag. Also follow the recommendations of the coatings manufacturers.

15

Image 15
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyService Specific Safety RulesSymbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Electrical Connection Cord Length Wire Size A.W.GElectrical Double InsulationProduct Specifications FeaturesAssembly Selecting Sanding Belts Setting the Belt Sander SpeedOperation ApplicationsTo F Proper Hand PlacementVariable Speed Turning ON/OFF the SanderTo INSTALL/CHANGE Sanding Belt Unplug your sanderPosition sander as shown Excessive pressure will result in the following Locking on the SanderOperating the Sander To lock-on the sanderTo Adjust Sanding Belt Tracking To install/remove dust bag Dust BAGTo empty dust bag Maintenance General MaintenanceLubrication See Figures 11 Timing Belt ReplacementService Model NO. and Serial no