Ryobi BE318-2 manual General Maintenance, Lubrication

Page 15

MAINTENANCE

WARNING:

When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage.

WARNING:

Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commu- tators, etc. Consequently, we do not recommended using this tool for extended work on these types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.

15

Image 15
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyService Specific Safety RulesSymbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Extension Cords ElectricalDouble Insulation Electrical ConnectionFeatures Packing List AssemblyOperation UnpackingSelecting Sanding Belts Using Sanding BeltsSee Figures 5 To Adjust Sanding Belt TrackingUsing the Dust Collection BAG To Attach the Dust Collection BAGTo Empty the Dust Collection BAG Turning ON/OFF the Sander Locking on the SanderOperating the Sander Helpful Tips Proper Hand PlacementMaintenance General MaintenanceLubrication Service Model NO. and Serial no