Dixon Specifications for ZTR Lawn Mowers and Tire Details

CHASSIS:

BODY:

MOWER DECK:

BLADE DRIVE: TRANSMISSION:

ENGINE:

Model 4421:

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE: CAPACITIES:

DIMENSIONS:

Page 8

SPECIFICATIONS

Model ZTR 4421

Hand welded 11 gauge structural tubing.

All body parts are made of rotationa l molded, high density polyethylene. Front body contains access panel for battery service. Seat lifts forward or backward for a variety of service points in the transmission area.

13 GA stamped steel construction.

(3) blades combine for a 42" cut width.

Cut height approximately 1" to 4" via 8 position lift handle.

Electric clutch.

Each rear wheel is independently driven by chain and sprockets through a friction, mechanical drive.

13 HP Diamond Series Briggs & Stratton, 4 -Cycle, Single Cylinder, Air- Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve.

Electric by key switch operation with safety interlock blade drive.

Front	410 X 3 . 50X4 ribbed tread.
Rear	18X9.50X8Turf Trac RS
Front	16-21 Ibs.
Rear	8-14 Ibs.
Fuel	2.4 gallons total.
Engine	Briggs & Stratton -1.25 quarts oil.
	Kohler - 2 quarts oil with filter.
Width	47" outside rear wheel measurement.
Height	39" to top edge of seat.
Length	67" hitch tab to front bumper.
Weight	480 Ibs.

NOTE: Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE