Dixon Comprehensive Guide to ZTR 4423 Specifications, Parts Diagrams, and Manuals

CHASSIS:

BODY:

MOWER DECK:

BLADE DRIVE: TRANSMISSION: ENGINE:

Model 4423:

Model 4424:

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE:

CAPACITIES:

DIMENSIONS:

SPECIFICATIONS

Models ZTR 4423 & ZTR 4424

The monocoque design chassis of the Models ZTR 4423 and ZTR 4424 incorporate CNC Laser and CMC brake processes to form the twin 12 gauge side frames and 7 gauge transmission and engine base plate.

All body parts are made of rotational molded, high density polyethylene. Front body contains access panel for battery service. Seat lifts forward or backward for a variety of service points in the transmission area.

13 GA stamped steel construction.

(3) blades combine for a 42" cut width.

Cut height approximately 1 B1o-4" via 8 position lift handle.

Electric clutch.

Each rear wheel is independently driven by chain and sprockets through a friction, mechanical drive.

14 HP Vanguard Briggs & Stratton, 4 -Cycle, Single Cylinder, Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve, Oil Pump With Integral Oil Filter.

15HP Kohler Command 15, 4 -Cycle, Single Cylinder, Overhead Valve, Air- Cpoled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft, Aluminum Head and Block with Cast-iron Cylinder Liner.

Electric by key switch operation with safety interlock blade drive.

Front	11 X 4.00 X 5 ribbed tread.
Rear	18 X 9 . 50X8 Turf Trac RS
Front	16-21 Ibs.
Rear	8-14 Ibs.
Fuel	2.7 gallons total.
Engine	Briggs & Stratton -1.50 quarts oil.
	Kohler - 2 quarts oil with filter.
Width	47" outside rear wheel measurement.
Height	42" to top edge of seat.
Length	72" hitch tab to front bumper.
Weight	520 Ibs.

NOTE: Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 9