Ryobi TS1344L manual To Adjust the Laser Guide, Laser Assembly Laser Adjustment Screw

Page 28

ADJUSTMENTS

DANGER:

Laser radiation. Avoid direct eye contact with light source.

WARNING:

Use of controls or adjustments or performance of pro- cedures other than those specified herein can result in hazardous radiation exposure.

TO ADJUST THE LASER GUIDE

See Figure 34.

Use the work clamp or a C-clamp to secure a piece of scrap wood.

Plug the saw into the power source and make a slight cut to score the wood.

Release the switch trigger and allow the saw blade to stop rotating before raising the blade.

Raise the saw arm.

Unplug the saw.

Using the Phillips end of the supplied blade wrench, loosen the laser adjustment screw and move laser assembly until aligned.

NOTE: When properly aligned, the laser should be on the left edge of the kerf.

Holding the laser assembly, tighten the laser adjustment screw.

LASER

ASSEMBLY

LASER ADJUSTMENT

SCREW

Fig. 34

Image 28

Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionRead ALL Instructions General Safety Rules Blade Coasts After Being Turned OFF Specific Safety Rules  Before Making a CUT, be Sure ALL ADJUST- Ments are SecureSpecific Safety Rules Symbols Symbol Signal MeaningElectrical Double InsulationElectrical Connection Extension CordsGlossary of Terms Features Product SpecificationsSwitch Trigger Lower Blade Guard Dust BAG Bevel Lock Knob Blade Miter Wrench Fence BaseKnow Your Compound Miter SAW AMP MotorBevel Lock Knob Blade Wrench StorageTools Needed Loose Parts Assembly UnpackingMounting Holes Trace HolesTo install the work clamp Dust BAGWork Clamp TightenAligning the Laser Guide Line Installing Batteries for LaserBatteries Compartment Cover Screw Laser Line To Install / Replace the Blade See Figures 13Spindle Lock Button Blade Bolt Cover Outer BladeSquaring the SAW Blade to the Fence See Figures 15Socket Head Screws Fence Miter View of Blade Square with FenceMiter Scale Indicator Fence Indicator Screw Bevel ScaleSquaring the Blade to THE MITER Table See Figures 19Blade Combinationmiter Square Table MiterOperation ApplicationsTo Cross CUT Cross CUTIndicator To Bevel CUTSee Figures 24 Bevel ScaleSee Figures 26 To Compound Miter CUTCompound Miter CUT To Support Long Workpieces 45 X 45 Compound Miter CUT Long Workpiece Workpiece SupportsCutting Compound Miters COMPOUND-ANGLE Settings for Popular StructuresPitch Number of Sides Cutting Crown Molding Laying Molding Flat on the Miter TableCeiling Fence Right SIDE, Outside Corner Miter Table Inside FenceCutting Warped Material Clamping Wide WorkpiecesSee Figures 30 WrongAdjustments Pivot Adjustments Travel Pivot AdjustmentBevel Pivot Adjustment Positive Stop AdjustmentsTo Adjust the Laser Guide Laser Assembly Laser Adjustment ScrewMaintenance General MaintenanceBrush Replacement Brush CAP AssemblyService Model NO. and Serial no