Ryobi BT3100 manual Assembling Storage Brackets, Mounting the LEG Stand on the Table SAW Base

ASSEMBLY

ASSEMBLING STORAGE BRACKETS

See Figure 9.

■Take storage brackets from loose parts.

■Take the following hardware from the leg stand hardware bag:

4 screws (1/4-20 x 1/2 in. Pan Hd.)

4 hex nuts (1/4-20)

4 washers (1/4 in.)

■Secure storage brackets to upper braces of leg stand as shown in figures 8 and 9.

MOUNTING THE LEG STAND ON THE TABLE SAW BASE

See Figure 10.

■Take the following from a small hardware bag:

4 hex bolts (1/4-20 x 3/4 in.)

4 hex nuts (1/4-20)

8 flat washers (1/4 in.)

Note: This hardware was in the bag with hardware for assembling the leg stand and leveling feet.

WARNING:

Do not lift the saw without help. The saw base weighs approximately 75 lbs. Hold it close to your body. Keep your knees bent and lift with your legs, not your back. Ignoring these precautions can result in back injury.

■Place the leg stand on the table saw base. Align the holes in the table with the holes in the end braces.

■Place a flat washer on a bolt and insert through hole. Add a flat washer and a hex nut. Hand tighten. See Figure 10.

■Repeat for three remaining holes. Tighten all hardware with a wrench. You may find it helpful to use one wrench to hold the head of the bolt and one to tighten the hex nut.

STORAGE BRACKET(S) UPPER BRACE

LOWER BRACE

LEG

LEG STAND ASSEMBLED

Fig. 9

WARNING:

Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury.

TO INSTALL FRONT AND BACK RAILS

See Figures 11 and 12.

■Position end plugs on both rails and secure in place by tapping with a block of wood or a rubber mallet.

■Loosen the front rail clamps one half turn from the tightened position. Loosen the square rail holder nut one-fourth (1/4) turn to allow the front rail to slide over it. See Figures 11 and 12.

■Mount the front rail with the scale facing the outside toward the operator.

SAW BASE

FLAT

WASHER

LEG STAND

HEX NUT

HEX BOLT

Fig. 10

Page 16