Ryobi csb140lz manual Cross CUTTING/RIP Cutting

Page 17

OPERATION

CROSS CUTTING/RIP CUTTING

See Figure 18.

When making a cross cut or rip cut, align the line of cut with the outer blade guide notch on the base as shown in the figure.

Since blade thicknesses vary, always make a trial cut in scrap material along a guideline to determine how much, if any, you must offset the guideline to produce an accurate cut.

NOTE: The distance from the line of cut to the guideline is the amount you should offset the guide.

TO RIP CUT WITHOUT EDGE GUIDE

See Figure 19.

Use a guide when making long or wide rip cuts with the saw.

Follow these directions to rip cut.

nSecure the workpiece.

nClamp a straight edge to the workpiece using C-clamps.

nSaw along the straight edge to achieve a straight rip cut.

NOTE: Do not bind the blade in the cut.

TO RIP CUT WITH EDGE GUIDE

See Figure 19.

Follow these directions to use the edge guide.

nSecure the workpiece.

nPosition the face of the edge guide firmly against the edge of workpiece.

nGuide the saw along the edge to achieve a straight rip cut.

NOTE: The guiding edge of the workpiece must be straight for your cut to be straight. Use caution to prevent the blade from binding in the cut.

TOP VIEW OF SAW

BLADE GUIDE

NOTCH

GUIDELINE

Fig. 18

STRAIGHT

EDGE

GUIDELINE

C-CLAMPS

WORKPIECE

WORKPIECE

GUIDELINE

EDGE GUIDE

Fig. 19

17

Image 17
Contents Save this Manual for Future Reference Operators ManualIntroduction Table of ContentsElectrical Safety General Safety RulesPersonal Safety Work AreaService Specific Safety RulesLaser Guide Warnings Symbol Name DESIGNATION/EXPLANATION SymbolsService Double Insulation ElectricalElectrical Connection Extension CordsProduct Specifications FeaturesAssembly See Figures 2 Attaching BladeRemoving Blade To Attach Dust Nozzle Dust Nozzle KITApplications OperationKickback See Figures 7STARTING/STOPPING the SAW SAW BladesBlade Guard System Adjusting Blade Depth Using the Laser GuideSee Figures 15 Operating the SAWCross CUTTING/RIP Cutting See Figures 20 Bevel CuttingLength of CUT Scale Positive 0 Bevel StopPocket Cutting AdjustmentsAdjusting the Laser General Maintenance MaintenanceLubrication Replacing Laser Guide BatteriesPage Page CSB140LZ Service Model NO. and Serial no