Ryobi 4060310 manual Tools Needed, Assembly, Installing the Miter Slot Table

TOOLS NEEDED

7/16 in. NUT DRIVER

3/16 in. HEX KEY

Fig. 2

ASSEMBLY

WARNING:

The table saw should never be connected to a power supply while you are assembling parts. Disconnect- ing the table saw will prevent accidental starting that could cause serious personal injury.

INSTALLING THE MITER SLOT TABLE

See Figure 3.

■Turn the ON/OFF switch to the OFF position.

■Unplug the saw from the switched on-board outlet.

■Disconnect the saw from the power supply.

■Remove the sliding miter table and accessory table from the saw.

■Place the miter slot table onto the saw as shown in Figure 3.

1/4-20 x 1 in.

MITERHEX CAP SCREW SLOT TABLE

SHIMS

WASHER

1/4-20 NUT

Fig. 3

4