ASSEMBLY
REAR VIEW
MITER
SLOT TABLE
HEX CAP SCREW
PLACE SHIMS
AS SHOWN
SHIMS
FRONT VIEW
ALIGNING THE MITER SLOT TABLE
See Figure 4.
■Place the miter slot table on the saw as shown in Figure 4.
■Extend a straight edge across the saw table onto the miter slot table and note any space between the straight edge and the miter slot table. If space ex- ists, place one of the shims under the miter slot table and recheck. Add shims as required between the miter slot table and the saw table to allow the miter slot table to be flush with or slightly lower than the saw table. Repeat the process for the rear of the miter slot table. Recheck in front and rear to assure that the miter slot table is not above the surface of the saw table.
■Place mounting bolts with washers through holes in the miter slot table and the saw table frame as shown in Figure 5. Place a nut under the lip of the saw frame on each bolt. Tighten firmly and evenly. Shims will be secured when you tighten the screws.
■Replace the sliding miter table and the accessory table.
NOTE: The miter slot table must not be higher than the saw table.
HEX CAP SCREW
WASHER
WASHER
Fig. 4
MITER
SLOT TABLE
SHIM
Fig. 5
5