453401 1102 11/12/02 3:02 PM Page 2
Operation (Continued)
3.Connect roller to gun and position at desired angle. Tighten with wrench.
PRESSURE ADJUSTMENT
1. For units with a single prime/pressure control, turn
the control knob approximately one turn from the prime position.
IMPORTANT: Very little pressure is required for rolling.
2.Set sprayers with separate pressure control at lowest pressure which provides a steady flow of paint.
PAINT APPLICATION
1.Trigger gun until paint appears on roller.
2.Roll roller on wall until roller is saturated.
3.Begin painting and trigger often enough to keep rolling smooth and effortless.
Maintenance
1. Remove the slotted bolt and pull the cover off.
| Roller | Cover |
|
| End Caps |
Figure 2 |
|
|
www.chpower.com | 2 |
|