Bostitch N88WW/N88RH manual Loading the N88, To Prevent Accidental Injuries

Page 6

LOADING THE N88

EYE PROTECTION which conforms to ANSI specifications and provides protec- tion against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when loading, operating or ser- vicing this tool. Eye protection is required to guard against flying fasteners and debris, which could cause severe eye injury.

The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the requirements of the American National Standards Institute, ANSI Z87.1-1989 and provide both frontal and side protection. NOTE: Non-side shielded spectacles and face shields alone do not provide ade- quate protection.

TO PREVENT ACCIDENTAL INJURIES:

Never place a hand or any other part of the body in nail discharge area of tool while the air supply is connected.

Never point the tool at anyone else.

Never engage in horseplay.

Never pull the trigger unless nose is directed at the work.

Always handle the tool with care.

Do not pull the trigger or depress the trip mechanism while loading the tool.

N88WW

1. Load nails.

2. Pull pusher back all the way.

3.Allow pusher spring to pull the pusher forward until it contacts the last nail.

N88RH

1. Open the magazine:

2. Load Nails:

 

 

 

Pull pusher back to

Hold nailer down with

 

 

 

 

engage the latch.

magazine tilted downward.

 

 

 

 

 

 

 

 

 

Insert stick of nails

3. Close Magazine:

Release pusher by first pulling back on the pusher and then pressing the pusher release tab. Slide pusher against nails.

NOTE: Use only nails recommended for use in Bostitch N88 series nailers or nails which meet the Bostitch specifications.

-6-

Image 6
Contents N88WW/N88RH Limited Warranty IntroductionIndex Loading Tool Safety InstructionsAIR Supply and Connections OperationN88 Tool Specifications AIR Supply and Connections LubricationN88RH Loading the N88N88WW To Prevent Accidental InjuriesFastener Depth Control Adjustment Directional Exhaust DeflectorRemoving Nails Contact Trip Operation Tool OperationOperation Sequential Trip OperationTool Must Cycle Tool Operation CheckTool Must not Cycle BOSTITCH, INCAIR SUPPLY-PRESSURE and Volume Replacement PartsAssembly Procedure for Seals Maintaining the Pneumatic ToolTrouble Shooting Problem Cause CorrectionN88 Driver Maintenance Instructions