Bostitch N88WW/N88RH manual Fastener Depth Control Adjustment, Directional Exhaust Deflector

Page 7

FASTENER DEPTH CONTROL ADJUSTMENT

The Fastener Depth Control Adjustment feature provides control of the nail drive depth from flush with or just above the work surface to shallow or deep countersink.

TO ADJUST THE FASTENER

DEPTH CONTROL:

DISCONNECT TOOL FROM AIR SUPPLY BEFORE ATTEMPTING

ANY PARTS DISASSEMBLY AND BEFORE CHANGING THE WORK

CONTACTING ELEMENT ADJUSTMENT.

1. Push in on locking button.

2. Adjust contact arm up to increase

 

PUSH IN

 

 

depth of drive or down to decrease it.

ADJUST

 

 

RELEASE

3. Release locking button

LOCKING BUTTON CONTACT ARM

DIRECTIONAL EXHAUST DEFLECTOR

Exhaust Deflector

The adjustable exhaust deflector can be rotated into any desired position by hand without the use of any tools.

NOTE: N88 Series share the same tool free adjustable exhaust deflector.

REMOVING NAILS

N88WW

PUSHER

PUSHER LEVER

NAIL STOP

1.Push down on pusher lever

2.Allow pusher spring to pull the pusher forward until it stops in the forward position

3.Slide the nails back to the nail stop

4. Push down on

5. Slide the nails out

the nail stop

of the magazine

N88RH

2

1. Pull pusher back until it engages latch.

2. Slide nails back to opening and push out.

1

-7-

Image 7
Contents N88WW/N88RH Introduction Limited WarrantyIndex Operation Safety InstructionsAIR Supply and Connections Loading ToolN88 Tool Specifications Lubrication AIR Supply and ConnectionsTo Prevent Accidental Injuries Loading the N88N88WW N88RHDirectional Exhaust Deflector Fastener Depth Control AdjustmentRemoving Nails Sequential Trip Operation Tool OperationOperation Contact Trip OperationBOSTITCH, INC Tool Operation CheckTool Must not Cycle Tool Must CycleMaintaining the Pneumatic Tool Replacement PartsAssembly Procedure for Seals AIR SUPPLY-PRESSURE and VolumeProblem Cause Correction Trouble ShootingN88 Driver Maintenance Instructions