Grizzly T10499 specifications Welding, Disconnect Welder from Power

Note: You can make sure that the blade ends are even with each other by stacking them together with the teeth facing in oppo- site directions (see Figure 11), then grinding them. Regardless of the grinding angle, the blade ends will match evenly for welding.

Figure 11. Blade ends stacked with teeth facing

opposite directions.

3.Use 120-grit emery cloth or an equivalent to lightly sand the part of the blade that will contact the welder clamps. This helps ensure a good electrical contact with the blade for welding.

Note: To prevent dulling the teeth, keep the emery cloth away from them when sanding the blade surface.

Welding

1.Turn the main ON/OFF switch OFF, then

DISCONNECT WELDER FROM POWER!

2.Thoroughly clean the welding clamps to remove debris, oily substances, or flash from previous welding operations. If necessary, lightly sand them with 120-grit emery cloth.

-8-

3.Rotate the clamp pressure switch (see Figure 12) to zero. This spreads the clamps apart to allow proper positioning of the blade ends.

Welding Clamps	Clamp
	Pressure
	Switch
Clamp Levers

Figure 12. Clamping controls.

4.Pull the spark deflector up and loosen the welding clamps by pulling the clamp levers down.

5.Position the back of one blade end evenly against the back of the right welding clamp so that the end is midway between the two clamps, as shown in Figure 13.

Blade

End

Figure 13. Blade end properly position in

welding clamp and locked in place.

6.Rotate the right clamp lever up to secure the blade end in place.

T10499/T10500 Blade Welder