UNPACKING
When unpacking, check to make sure all parts shown on the Parts List (page 12) are in- cluded. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly Diagram on page 13 of this manual.
To Attach The Upper And Lower Tongs:
1.Caution: Prior to attaching the Upper and Lower Tongs (parts #46, #47), make sure the Spot Welder is disconnected from its electrical power source.
2.NOTE: Make sure the Upper and Lower Tongs (parts #46, #47) are clean and not corroded before installing. If necessary, clean the Tongs with steel wool.
3.To attach the Lower Tong (part #47) to the Spot Welder, loosen the four Cap Screws (part #3) located at the bottom/front of the tool. (See Figure A, and Assy.
Diagram.)
4.Slide the Lower Tong (part #47) between the Tong Insulator (part #33) and Lower Tong Clamp (part #35), and position the Lower Tong so that the Tong Tip (part #48) faces up.
5.NOTE: Check to make sure the Lower Tong (part #47) will align with the Upper Tong (part #46) when fully assembled. (See Figure B, and Assy. Diagram.)
6.
7.To attach the Upper Tong (part #46) to the Spot Welder, loosen the four Cap Screws (parts #3, #11) located at the top/front of the tool. (See Figure A, and Assy.
Diagram.)
8.Slide the Upper Tong (part #46) between the Tong Tip Holder (part #12) and Upper Tong Clamp (part #13), and position the Upper Tong so that the Tong Tip (part #48) faces down.
9.NOTE: Check to make sure the Upper Tong (part #46) will align with the Lower Tong (part #47) when fully assembled. (See Figure B, and Assy. Diagram)
SKU 45690 | PAGE 5 |