Global Machinery Company DC750 Attaching the dust bag, Turning on and off, Operation

3.Ensure it is pushed all the way on and is secure on the hose.

4.Tighten the hose clamp using a flat end screwdriver to secure the 2 way adaptor onto the hose (fig. H).

5.When using only 1 tool fit

the cap onto the end of the other hole in the 2 way adaptor (fig. I).

H I

Attaching the dust bag

1.Fit the dust bag over the outlet (3) (fig. J).

2.Place the dust bag strap through the metal clamp.

3.Pull the strap to secure the dust bag on the outlet cover (fig. K).

J K

Turning on and off
	L
1. Insert the switch disabling
insert and ensure the switch

(1)is in the OFF position (fig. L).

2.Lift the switch to the ON position (I) to turn on and operate the dust collector (fig. M).

3.Push the switch down to the OFF position (0) to turn off the dust collector (fig. N).

M N

Operation

1.Fit the hose onto the inlet.

2.If the dust outlet on the power tool is 100mm in diameter the hose can be connected directly onto the power tool.

3.If the power tool has a smaller outlet fit the 2 way adaptor onto the end of the hose. Connect a smaller diameter hose (not supplied) onto the adaptor and connect this to your power tool.

Note. The 2 way adaptor is designed for fine dust ie. sanding dust. If larger particles are being collected and blocking occurs remove the cap to draw air into the hose and increase airflow.

Emptying the dust bag

The dust bag can be emptied either on or off the dust collector. The bag should be emptied when the dust bag is approximately half full, performance will deteriorate as the dust in the dust bag exceeds this level.

Ensure that the zip is not opened or the dust bag is not removed from the dust collector until the dust collector is turned off and the impellor has completely stopped rotating. Failure to do this can result in dust particles being distributed in the air.

It is best to place the dust bag into a large garbage bag and then empty the dust directly into the garbage bag.

8