Global Machinery Company DC750 instruction manual Attaching the wheels, Attaching the hose

Introduction

The dust collection system is specifically designed to capture sawdust and woodchips. NEVER use as a vacuum.

CAUTION. The dust collector housing features a high speed fan that can amputate fingers, grab loose clothing and neckties, or propel dust at high velocities.

CAUTION. This dust collector does not eliminate the need to wear a protective dust mask. Always follow the safety recommendations from the manufacturer or supplier of the material being cut and collected in the dust collector.

DO NOT OPERATE WITHOUT ALL PARTS IN PLACE!

Do not attempt to clean, remove dust bags or service unit while in operation. Disconnect from the power source.

Attaching the wheels

The wheel castors allow the dust collector to be moved easily around the work area.

1.Place the dust collector on its side.

2.Screw one castor wheel (5) into each corner of the base (fig. A).

3.To secure the wheels onto the base tighten the hex nut on each wheel using a 14mm wrench (fig. B).

Note. When fitting the last castor wheel, screw the wheel in sufficiently to allow all four wheels to be in contact with the floor surface.

A B

Attaching the hose			C
1.	Fit the hose clamp (8) over the
		end of the hose (7) but do not
		tighten the clamp (fig. C).
2.	Fit the hose onto the inlet (2)
		(fig. D).
3.	Ensure it is pushed all the
		way on and is secure on the
		inlet cover.
		D	E

4.Tighten the hose clamp using a flat end screwdriver to secure the hose on the inlet (fig. E).

Attaching the 2 way adaptor

The 2 way adaptor (9) allows up to 2 tools to be operated at the same time.

1.Fit the hose clamp (8) onto the end of the hose (7) but do not tighten (fig. F).

F G

2. Fit the 2 way adaptor (9) onto the end of the hose (fig. G).

7