Grizzly G1029Z instruction manual Inlet, Installing Y inlet G1028Z/G1029 Dust Collector

Page 17

3.Slip the steel band around the bag and tight- en down as shown in Figure 10.

Figure 10. Tightening steel band.

4.Slip the bottom collection bag over the bot- tom edge of the collector and pull the strap tight to secure the bag.

5.Place the steel band with the quick clamp over the bag and clamp on the tightest notch possible.

DO NOT force the clamp. Instead, choose the next notch over, then clamp in place.

Inlet

Press the “Y” inlet onto the inlet cover flange as shown in Figure 11. The inlet is secured to the collector body by a press-on fit.

Figure 11. Installing “Y” inlet.

-14-	G1028Z/G1029 Dust Collector

Image 17

Contents Micron 2 HP Dust Collector Manual InsertModel G1028Z/G1029 Dust CollectorPage Table Of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Dust Collector Circuit Requirements G1028Z WiringGrounding Extension Cords Commentary IntroductionPiece Inventory UnpackingSite Considerations Clean UpBeginning Assembly Base AssemblyOutlet Collector BodyCollector Support BracketsSecuring collection bag G1028Z/G1029 Dust Collector Flex Hose BagsInlet Installing Y inlet G1028Z/G1029 Dust CollectorMaterial Selection GeneralPlastic Duct System GroundingFlex-hose grounded to machine G1028Z/G1029 Dust Collector Bird’s eye planning view G1028Z/G1029 Dust Collector Design SuggestionsTest Run OperationsLubrication MaintenanceBag Cleaning Closure Wire Diagram Machine Data Sheet 6A G1029 Caster Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC