7.Place the ring over the top of the plastic bag and fold over the bag approximately three inches, Figure 7.
8.Insert the snap ring (A, Fig. 8) of the collector bag into the bottom of the housing at an angle.
9.Pull down on the ring to make sure it “seats” in the housing.
Note: make sure the snap ring “snaps” into place in the housing, and also that the plastic bag hangs down approximately 3” so that there are no air leaks.
10.Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock washer, see Figure 9.
8