Filter Bag Kit Assembly

If you purchased DC-1100BK Dust Collector, this section describes the assembly and installation of the contents of the Filter Bag Kit (SN 708636F).

Filter Bag Installation

Referring to Figure 7:

1.Place the hanger (A) on the hanger bracket (B).

2.Slide the filter bag loop (C) over the hanger hook.

3.Feed the retainer strap (D) through the loops on the filter bag (E) and fasten to the collector housing (F).

Figure 7

Collector Bag Installation

Referring to Figure 8:

4.Insert the ring of the collector bag (A) at an angle into the housing (B) through the opening at the bottom. Pull down on the bag to make sure it “seats” in the housing.

5.Position the plastic window in front so that you can easily see when the collector bag is full.

After completing the filter bag and collector bag installation, proceed to Electrical Connections.

Figure 8