Jet Tools DC-1100CK operating instructions Connector Housing, Hose

Connector Housing

5.Attach three support legs (A, Fig. 4) to the base using six M8 x 16 hex cap bolts and six M8 flat washers (B, Fig. 4). Hand-tighten only at this time.

6.Install the housing (A, Fig. 5) to two support legs (B, Fig. 5) using four M8 x 16 hex cap bolts, eight M8 flat washers, and four M8 hex nuts (C, Fig. 5). Be sure hose opening faces fan housing.

Note: For model DC-1100BK only – Before attaching third support bracket place the hanger bracket (D, Fig.5) between the support bracket and the housing.

7.Tighten all nuts and bolts at this time with a 13mm wrench.

Figure 4

Figure 5

Hose

Referring to Figure 6:

8.Attach the hose (B) between the fan housing (A) and the impeller housing (D) with two clamps (C). Tighten the clamps to secure the hose.

This completes the Base Unit assembly. If you purchased the DC-1100BK Dust Collector (filter bag version), continue on the following page. If you purchased the DC-1100CK Dust Collector (canister filter version), proceed to Canister Kit Assembly section on page 12.

Figure 6

10