D3038 Remote Dust Collector Switch
6.Turn the remote control transmitters ON with the ON/OFF switch shown in Figure 5. The LED indicators will light to show the transmitters are working.
—If the LEDs don't light, remove the protective covering from the batteries. See Replacing Batteries below to access the batteries.
Note: To conserve battery life in the remote control transmitters, only turn them on when they are needed for use.
7.Turn the switch on the dust collector unit to the
ON position. Test the function of the remote dust collector switch by pressing the ON and OFF buttons on each remote.
ON/OFF Switch
Figure 5. ON/OFF Switch location.
Replacing Batteries
1.Remove the two screws from the back of the remote control transmitter.
2.Remove the back of the remote control transmitter, as shown in Figure 6.
3.Remove the existing battery, then install a new 9V battery.
4.Replace the back of the remote transmitter and secure it with the two screws removed in Step 1.
Tip: During
Figure 6. Battery installation/
replacement.
Troubleshooting
PROBLEM |
| POSSIBLE CAUSE |
| corrective action |
Unit will not turn on. | 1. | Remote is out of range. | 1. Move remote closer to receiver unit. | |
| 2. | Signal is obstructed. | 2. | Remove obstructions to provide direct line of sight |
|
|
|
| between remote and receiver. |
| 3. | Remote is not turned ON. | 3. | Turn ON remote control transmitter. |
| 4. | Dust collector is turned OFF | 4. | Turn ON dust collector. |
| 5. | Receiver circuit breaker has | 5. | Allow unit to cool, then press the button on the |
|
| tripped. |
| bottom of the receiver unit to reset breaker. |
6.Wall circuit breaker has tripped. 6. Reset wall circuit breaker. Check that breaker is in good condition and circuit is properly sized for the dust collector in use.
7. Remote battery is weak/dead. | 7. Replace weak/dead battery. |
8.Connected to a machine with a 8. Only use this unit on machines with standard ON/
| magnetic switch. |
| OFF toggle switches. |
9. | Dust collector is at fault. | 9. | Refer to dust collector manufacturer's |
|
|
| documentation for troubleshooting. |
10. | Remote control transmitter is at | 10. | Check/use second remote. |
| fault. |
|
|
11. | Receiver unit is at fault. | 11. | Replace unit. |