Maintenance

Safety (52)

FIGURE 2

Safety

Cover (54)

3.Lift the Safety Cover (54) off the top of the stapler - see Figure 2.

FIGURE 3

	Driver
Driver	Cover
(19)	(57)

4.Carefully slide the Driver Cover (57) off around the Safety (52) and remove the jammed staple - see Figure 3. Use pliers to remove a stuck staple.

5.Inspect the Driver (19) for bends or breakage - see Figure 3. If it is damaged, do not use the tool until it is repaired by a qualified technician.

6.Lightly oil the Driver (19) and replace the Driver Cover (57). Replace the Safety Cover (54), being careful to line up the bolt holes and fit the Safety (52) into the slot. Replace and securely tighten all of the Safety Cover Bolts (53). The Safety (52) must move without sticking.

7.Reload the Stapler.

8.Reconnect the Stapler to the air hose.

9.Press the Safety (52) of the Stapler against an appropriate piece of scrap wood and test fire the Stapler several

times, checking for proper operation.

REV 10a

10.Disconnect the Stapler, remove the staples, and store the Stapler in a location out of children’s reach.

To prevent serious injury

from accidental operation,

BEFORE ANY MAINTENANCE OR REPAIRS ARE DONE (including clearing jams):

•Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.

•Release the trigger.

•Detach the air supply.

•Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners.

•Empty the magazine and leave it open during service.

Note: If the Stapler leaks air, continually skips staples, does not drive the staple properly, or the Trigger (39) or Safety

(52) do not move freely have it serviced by a qualified service technician.

1.After each use, check the tightness on all visible screws.

2.Wipe the Stapler clean daily with a damp cloth and non-flammable cleaning solution. Never soak the Stapler.

3.Make sure that no dirt or debris blocks the fastener discharge area.

4.Any maintenance, service, or repairs, apart from those procedures explained in this manual, are to

be attempted only by a qualified technician.

SKU’s 40072,	For technical questions, please call 1-800-444-3353.	Page 9
40073, & 97521