Harbor Freight Tools 54425 operating instructions Assembly Instructions, Operating Instructions

ASSEMBLY INSTRUCTIONS

NOTE: For additional references to the parts listed on the following pages, refer to the Assembly Diagram on page 10.

To Attach A Quick Connector To The Air Stapler:

1.The Air Stapler requires the attachment of a 1/4”-18 NPT Quick Connector (not included) to the Air Plug (part #33) of the Air Stapler. To do so, wrap the threaded portion of the Quick Connector with about 3” of pipe thread seal tape (not included). Then, wrench tighten the Quick Connector into the Air Plug (See Figure B.)

AIR PLUG (#33)

			QUICK CONNECTOR
			(NOT INCLUDED)
TRIGGER	WRAP THREADED PORTION
	WITH 3” PIPE THREAD SEAL
(#31)
		(NOT INCLUDED)

FIGURE B	NOSE
		SAFETY ELEMENT (#55)

OPERATING INSTRUCTIONS

To Prepare The Air Stapler For Use:

1.CAUTION: Make sure to keep the Air Stapler pointed away from you

and others at all times. Always disconnect the Air Stapler to its air supply before loading nails. Do not load nails with the Trigger (part #31) or Safety Element (part #55) depressed. (See Figure C, next page.)

2.Lift the Magazine Latch (part #39) up, and pull the Moving Rail (part #76) all the way to the rear until it latches. (See Figure C.)

3.Orient a strip of Staples with the points down, and drop the strip of Staples into the Moving Rail (part #76). (See Figure C.)

SKU 54425 PAGE 6