Grizzly H7677 instruction manual Clearing Jammed Staples

Page 12

To operate your stapler in bump fire mode:

1.Push the trigger switch IN (Figure 7).

Figure 7. Trigger switch, bump fire mode.

2.Pull the trigger.

3.Press the safety yoke mechanism against your workpiece and raise it after the staple is driven.

4.Hold the trigger and repeat Step 3 to drive more staples.

Clearing Jammed

Staples

A jammed staple must be cleared before using the stapler again. The two places where a staple can get jammed are the magazine and the discharge area.

To clear a jammed staple from the dis- charge area:

1.DISCONNECT STAPLER FROM THE AIR SUPPLY!

2.Pull back and latch the magazine.

3.Remove the staple from the maga- zine.

4.Loosen the cap screws shown in Figure 8 and remove the nose cover.

Nose Cover

Cap Screw

 

Figure 8. Loosening cap screws on cover.

5.Remove the jammed staple with nee- dle nose pliers.

6.Secure the safety cover with the cap screws removed in Step 4.

7.Throw the damaged staple away.

8.Inspect the staple stick. If it is bent or damaged, insert a new staple stick that only contains clean, undamaged staples. DO NOT use dirty or damaged staples!

9.Latch the magazine closed.

-12-

H7677 18 Gauge Stapler Kit

Image 12
Contents Gauge Stapler KIT Safety Safety Instructions for Pneumatic ToolsBefore Operating This Equipment Safety Instructions for Pneumatic Tools Additional Safety Instructions for Staplers H7677 18 Gauge Stapler Kit Introduction Foreword Contact InfoTool Data SET UP UnpackingInventoryCompressed Air System Safety Yoke Disconnect Stapler from the AIR SupplyOperations LoadingOperating Single/Bump Fire Operation Clearing Jammed Staples Replacing Pistons/O Rings Maintenance CleaningLubricatingH7677 Parts Breakdown H7677 Parts List DescriptionTroubleshooting Symptom Possible Cause SolutionWarranty and Returns Warranty Card Place Stamp Here