Model D3736 Palm Finishing Sander
Troubleshooting
Symptom
Possible Cause
Possible Solution
Reduced amount of | 1. Sandpaper clogged with paint | 1. Replace sandpaper. |
material removed | or glue. |
|
by sander, quality | 2. Sandpaper grit dull. | 2. Replace sandpaper |
of finish decreases, |
|
|
sander slides easily |
|
|
across workpiece. |
|
|
|
|
|
Sander generates | 1. Dust bag full. | 1. Empty dust bag. |
excessive dust | 2. Holes on sandpaper not | 2. Use abrasive paper with |
particles. | aligned with holes in sander | |
| base. | match holes on base. |
| 3. Sandpaper lacks holes. | 3. Cut or punch holes in |
|
| sandpaper to match holes |
| 4. Holes in sander base clogged. | on sander base. |
| 4. Clean dust collection | |
|
| holes in base with dry |
|
| compressed air. |
|
|
|
Sander runs slowly, | 1. Excessive pressure placed on | 1. Apply less pressure on |
becomes hot, or | sander. | sander. |
sanding efficiency | 2. Brushes are at fault. | 2. Replace brushes. |
decreased. | 3. Motor is at fault. | 3. Replace motor. |
|
|
|
Sander fails to | 1. Sander plug prongs loose in | 1. Plug sander back into |
start. | wall outlet. | outlet so they fit snugly. |
| 2. Switch clogged with dust. | 2. Clean switch. |
|
|
|
Repair
All quality tools will eventually wear from normal use. Since this sander is encased in an insulated plastic cover, leave repair and service issues to a qualified service technician. This includes brush replacement, lubrication or any other internal operation.
See the Parts Breakdown on Page 9 for replacement parts.
You can replace the rubber backing |
| |
pad that holds the abrasive sheet if it |
| |
becomes worn. Remove the four screws |
| |
that hold the backing plate to the |
| |
body of the sander and replace with |
| |
a new rubber backing piece, installing |
| |
the reverse of removal. Make sure |
| |
you tighten the rubber backing screws |
| |
sufficiently, so you don’t have problems | ||
when you resume operations. | ||
|
Disassembly and improper reassembly of this device can result in electrical shock. Always have this device serviced by
a qualified electrical repair technician to avoid serious injury.