Model D3736 Palm Finishing Sander
Tip: Try using the sandpaper that came with your sander as a template for cutting holes in new 1⁄4 sheets to match those on the bottom of the
Using the Sander
Determine the appropriate grit size for your project and sand the work evenly in the same direction as the grain of the wood. Always keep the sander moving so the finish of your work stays consistent. If the sander stays in one place too long, then it may produce a depression in the wood that will compromise your finish.
Attaching Dust Bag
Using the dust bag will help keep your work area clean and reduce dust particle emission.
To install the dust bag, do these steps:
1.Insert the dust bag spout into the dust port and make sure it fits snugly.
2.When the dust bag is half full, remove the dust bag from the sander and empty it into a trash receptacle by gently tapping on the side of the bag.
Always wear a respirator or dust mask and safety glasses when emptying the dust bag.
Sanding across the grain of the wood may be necessary in some cases to remove rough defects. This should be done with caution, however, because it can produce
Electrical shock hazard! Only use sander for dry sanding. Never use sander for wet sanding!
Change sheets as soon as the grit becomes dull. And, never apply excessive force while sanding. Your sander and paper will last longer if you let them do the work.