Chicago Electric 94338 manual Tool Set Up, Attaching Sandpaper to the Backing Pad

Page 9

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Make sure that the Trigger is in the off‑position and unplug the tool from its electrical outlet before performing any procedure in this section.

Attaching Sandpaper to the Backing Pad (28)

1.Press the tab on the Clamp Wire (17) inward on both sides of the unit and swing the clamps on both sides up, out, and down. See photo below.

2.Cut the sandpaper to fit the 3-5/8” W x 7-3/8” L Pad (22), with a little extra to overlap and fit under the Clamp Wire (17).

Do not use torn or frayed sandpaper.

Clamp Wire (17)

 

3.After wrapping the overlapped edges of sandpaper under the Clamp Wire (17), push the Clamp Wire (17) back into it’s locking position, thus trapping the ends of the sandpaper in front and rear of the sander. The sandpaper should now be held securely in place.

Workpiece and Work Area Set Up

Safety

Setup

1.Designate a work area that is clean and well‑lit. The work area must not allow access by children or pets to prevent distraction and injury.

2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.

3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.

4.There must not be objects, such as utility lines, nearby that will present a hazard while working.

Operation

General Operating Instructions

1.Make sure that the Trigger is in the off‑position, then plug in the tool.

2.Hold the Sander securely with both hands. Turn on the Sander by turning on the Switch (3).

3.Always run the Sander for a few seconds before contacting the workpiece.

4.Contact the workpiece with minimal pressure. If the Sander is not removing enough material, try a grittier piece of sandpaper. If you want to remove a lot of material fast, use a belt sander.

Note: All sanders leave sanding marks on the workpiece. To minimize sanding marks, always try to sand with the grain of the wood.

5.Occasionally check the sandpaper for tears, wear, or fraying. Replace if necessary.

6.To prevent accidents, turn off the tool and unplug it after use. Clean, then store the tool indoors out of children’s reach.

Maintenance

Item 94338

For technical questions, please call 1-800-444-3353.

Page 9

Image 9
Contents Page Table of Contents General Power Tool Safety WarningsWork area safety Personal safety Electrical safetySafety Setup Operation MaintenanceOperation Maintenan Safet SetuVibration Safety Safety SetupOperation Maintenance Double Insulated Tools Tools with Two Prong Plugs Grounded Tools Tools with Three Prong PlugsSafet Setu Operation Maintenan GroundingSymbology Extension Cords25´ 50´ 75´ 100´ 150´ Specifications Assembly Attaching the Dust BagSetup Before Use SafetWorkpiece and Work Area Set Up Tool Set UpAttaching Sandpaper to the Backing Pad General Operating InstructionsTroubleshooting Cleaning, Maintenance, and LubricationMaintenance and Servicing Problem Possible Causes Likely SolutionsParts List and Diagram Safety Setup Operation MaintenancePart Description Qty Part DescriptionPlease Read the Following Carefully Limited 90 Day Warranty