Ballast Assembly Replacement Instructions
Ballast assembly can be replaced without the cutting of any wires. Use of a qualified electrician is recom- mended.
CAUTION: Make sure the power is off before starting the installation.
1.Remove bulb.
2.Loosen two screws holding plastic/aluminum reflector and remove reflector.
3.Remove two screws connecting ballast assembly to aluminum housing.
4.Remove tape from wire bundle. Be careful not to damage wires.
5.Label wires according to wiring diagram.
6.Remove wire nuts from wires. Retain wire nuts to connect replacement ballast assembly.
7.Remove screw holding ignitor to ballast assembly.
8.Remove two screws holding lamp socket to ballast assembly.
9.Dispose of used ballast assembly.
10.Connect the replacement ballast assembly following steps 1 through 8 in reverse order.
| Red |
|
| Photocell | |
|
|
|
| ||
|
|
|
| Socket | |
Black | Lamp |
| White | Black | |
Socket | Black | ||||
Red |
| White | |||
|
|
| Red | White |
|
| Blue | Blue |
|
| |
|
| White |
| ||
|
|
|
| Black | |
| Ballast |
|
|
|
|
|
|
| Ignitor | 120V AC | |
|
|
|
| Input | |
Aluminum
Housing
Ignitor Retention Screw 
Ballast Assembly
Lock Washer 
Ballast Retention Screw
Ignitor
Lamp Socket
Lamp Socket
Retention Screw