Elation Professional 60 Tri manual DMX-512 connection with DMX terminator

Design LED 60 TriStrip™

DMX-512 connection with DMX terminator

A DMX terminator should be used in all DMX lines especially in longer runs. The use of a terminator may avoid erratic behavior in your DMX line. A terminator is a 120 ohm 1/4 watt resistor that is connected between pins 2 and 3 of a male XLR connector (DATA + and DATA -). This fixture is inserted in the female XLR connector of the last fixture in your daisy chain to terminate the line. Using a line terminator (Elation part: DMX T PACK) will decrease the possibilities of erratic behavior.

5-Pin XLR DMX Connectors. Some manufactures use 5-pin XLR connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures may be implemented in a 3-pin XLR DMX line. When inserting standard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be used, these adaptors are readily available at most electric stores. The following chart details a proper cable conversion.

Understanding Fixture DMX addressing;

When using the fixture with a DMX controller the fixture should be given a DMX starting address. The starting DMX address ensures the fixture will respond to the correct control signal. This “starting address” is the channel number from which the fixture starts to “listen”

©Elation Professional, Los Angeles Ca. 16 www.ElationLighting.com