Instruction Manual | PRECISION SANDER ELITE |
Model F200-2
Operation
Preparation
1.Rotate alignment bar to either side by lifting and turning (Fig. 3)
Sanding
1.Place back of moulding against alignment bar with finish side up.
2.Slide moulding against wheel.
3.With one hand, hold moulding firmly against alignment bar and wheel. With other hand, rotate wheel
in the direction of the moulding or downward onto the top of the moulding.
(Figs. 4a and 4b)
4.Rotate wheel
•Adjust the pressure against the wheel while rotating. Start with light pressure until wheel
is spinning, then increase the pressure for easier sanding.
5.Check sanded surface of moulding to see if surface is smooth.
6.Repeat until full surface is smooth.
Check Lengths It is important both sides of moulding are same length for square frame and seamless corners.
1.Lay two moulding pieces
2.Align the two lower edges.
3.Check to see if the upper edges are even in length (Fig. 5).
4.If not, sand longer piece until it’s even with short piece.
Fig. 3 |
Fig. 4a | Fig. 4b | |
Right Side | ||
Left Side | ||
|
Fig. 5 | Check top |
Moulding
Pieces
Align Bottom
3
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084